Navegando por Autor "Milheiros, Idalina Sturião"

Agora exibindo 1 - 5 de 5

Genetic variability of conilon coffee population from cultivar ‘ES8152’ based on morphoagronomic variables
(Universidade Federal de Lavras, 2022-06-09) Senra, João Felipe de Brites; Silva, Josimar Aleixo da; Ferrão, Maria Amélia Gava; Esposti, Marlon Dutra Degli; Milheiros, Idalina Sturião; Fassarella, Kamila Machado
This study aimed to analyze the genetic variability of Coffea canephora population with 190 genotypes from cultivar ‘ES8152’, based on morphoagronomic characteristics and vegetation index, to identify the most important characteristics for genetic divergence and compare them with commercial clones. The experiment was installed, in 2019, at the Bananal do Norte Experimental Farm/INCAPER, Cachoeiro de Itapemirim, ES, Brazil. The experiment was carried out in Federer’s augmented block design with three blocks, four common treatments (commercial clones A1, LB1, V8 and V12) and 190 regular treatments, genotypes from the seed production field of the conilon coffee cultivar ‘ES8152’. At 24 months of age 14 morphoagronomic characteristics and vegetation index were evaluated. Descriptive analysis of the data, the estimation of the Standardized Euclidean Distance (ED) followed by the group-ing by the methods of Tocher, UPGMA and principal coordinates, in addition to the relative importance of the characters estimated by the Singh meth-odology were performed. The most distant genotypes were 62 and 83 (ED=2.620) and the closest were 42 and 160 (ED=0.208). Genotype 83 stood out as the most distant among the others. The optimization and hierarchical groupings allowed the identification of genotypes 15, 81, 107 and 184 as similar to commercial clones. The discard analysis of variables recommended the elimination of the vegetation index and average internode length of the next diversity analysis. Principal coordinate analysis found phenotypic similarity of the genotypes 30, 81, 115, 141 and 163 with the clone V12, of the genotype 119 with the clone A1 and genotype 17 with clone LB1. The study, of morphoagronomic characters, allowed to detection the genetic diversity existing in the materials evaluated, indicating those with phenotypic similarity with the commercial clones, being possible the early identification of promising genotypes, agronomically superior, to start a breeding program for clonal selection, recurrent selection and controlled crosses to maximize heterosis.
Initial performance and genetic diversity of coffee trees cultivated under contrasting altitude conditions
(Escola Superior de Agricultura "Luiz de Queiroz", 2023-08-14) Senra, João Felipe de Brites; Silva, Josimar Aleixo da; Ferreira, Adésio; Esposti, Marlon Dutra Degli; Ferrão, Maria Amélia Gava; Fassarella, Kamila Machado; Silva, Uliana Ribeiro; Milheiros, Idalina Sturião; Silva, Fernanda Gomes da
This work evaluated the initial performance and genetic diversity of Coffea canephora genotypes cultivated in environments at contrasting altitudes. Fourteen morphophysiological traits and seven descriptors of the genus Coffea spp. of coffee trees cultivated at altitudes of 140 m and 700 m were evaluated. The design used was Federer’s augmented block in a 2 × 112 factorial scheme with six blocks. The first factor was the two environments, and the second was the 112 genotypes, with eight common treatments, being five conilon coffee clones and three arabica coffee cultivars. The data were analyzed by the method of REML/BLUP and genetic correlation method. Genetic diversity was evaluated by estimating the distance matrix, applying the Gower methodology followed by the clustering method by Tocher and UPGMA. The phenotypic means were higher in the environment at an altitude of 700 m, except for plant height, number of leaves, and canopy height (CH). Genotypic effects were significant for most traits except for leaf width, CH, unit leaf area, and total leaf area. A wide genetic diversity was verified, with distances varying from 0.037 to 0.593 for the pairs of genotypes 26 × 93 and T7 × 76, respectively. Most of the traits studied showed high genotypic correlation with the environment and expressive genetic correlation between the evaluated traits thereby demonstrating the possibility of indirect selection. There is an adaptation of conilon coffee genotypes to high altitudes and the possibility of developing a specific cultivar for the southern state of Espírito Santo.
Morphophysiological responses of Conilon coffee matrix plants in a super-dense clonal garden
(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-12-04) Silva, Josimar Aleixo da; Esposti, Marlon Dutra Degli; Senra, João Felipe de Brites; Comério, Marcone; Conceição, Amanda Oliveira da; Zacarias, Alex Justino; Milheiros, Idalina Sturião; Silva, Uliana Ribeiro; Silva, Fernanda Gomes da; Raimundo, Eduarda Gonçalves
The objective of this work was to evaluate the morphophysiological responses and cutting production of clones of Conilon coffee (Coffea canephora) cultivars in a super-dense clonal garden in the state of Espírito Santo, Brazil. The super-dense clonal garden was built in 2019 using 39 clones: 9, 9, 9, and 12 of cultivars Centenária ES8132, Diamante ES8112, ES8122 (Jequitibá), and Marilândia ES8143, respectively. The experiment was carried out in a randomized complete block design, with three replicates. Cutting production and the following morphophysiological traits were evaluated at 9 and 18 months after planting: chlorophyll index, normalized difference vegetation index, plant height, canopy height, canopy diameter, number of shoots, number of viable cuttings, number of leaves, fresh leaf mass, and plant fresh and dry matter mass. The super-dense clonal garden caused different morphophysiological responses among the studied clones. In general, clones C2, C5, C6, C8, D1, D8, D9, J8, M2, M9, M10, and M12 showed a higher mean cutting production, whereas C4, J1, J4, M4, and M5 were the most sensitive to the super-dense regime. Under these conditions, it is recommended to increase the proportion of matrix plants of the latter clones.
Morphophysiological responses of Conilon coffee matrix plants in a super-dense clonal garden
(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-12-04) Silva, Josimar Aleixo da; Esposti, Marlon Dutra Degli; Senra, João Felipe de Brites; Comério, Marcone; Conceição, Amanda Oliveira da; Zacarias, Alex Justino; Milheiros, Idalina Sturião; Silva, Uliana Ribeiro; Silva, Fernanda Gomes da; Raimundo, Eduarda Gonçalves
The objective of this work was to evaluate the morphophysiological responses and cutting production of clones of Conilon coffee (Coffea canephora) cultivars in a super-dense clonal garden in the state of Espírito Santo, Brazil. The super-dense clonal garden was built in 2019 using 39 clones: 9, 9, 9, and 12 of cultivars Centenária ES8132, Diamante ES8112, ES8122 (Jequitibá), and Marilândia ES8143, respectively. The experiment was carried out in a randomized complete block design, with three replicates. Cutting production and the following morphophysiological traits were evaluated at 9 and 18 months after planting: chlorophyll index, normalized difference vegetation index, plant height, canopy height, canopy diameter, number of shoots, number of viable cuttings, number of leaves, fresh leaf mass, and plant fresh and dry matter mass. The super-dense clonal garden caused different morphophysiological responses among the studied clones. In general, clones C2, C5, C6, C8, D1, D8, D9, J8, M2, M9, M10, and M12 showed a higher mean cutting production, whereas C4, J1, J4, M4, and M5 were the most sensitive to the super-dense regime. Under these conditions, it is recommended to increase the proportion of matrix plants of the latter clones.
Selection of differentiated maturity genotypes of Coffea canephora
(Editora da Universidade Estadual de Maringá - EDUEM, 2025-06-02) Senra, João Felipe de Brites; Silva, Viviane Alexia Correia; Esposti, Marlon Dutra Degli; Ferreira, Adésio; Milheiros, Idalina Sturião; Ramos, Isabela Bolari; Oliveira, Rosana Gomes de; Benevenute, Lorran Marques
The aim of this study was to select Coffea canephora genotypes from the seminal propagation variety ‘ES8152’ with different harvest times. The experiment was conducted using a Federer augmented block design with three repetitions, evaluating 175 genotypes and four clonal witnesses in two harvests (2022 and 2023), and 20 morphoagronomic characteristics were evaluated. The data were analyzed using the REML/BLUP methodology with the Selegen software, where the variance components and genetic values were estimated. The selection was performed using the Mulamba-Rank index. The bottom sieve (BS) and top sieve (TS) characteristics had high heritability (0.5779 and 0.6694, respectively) and accuracy (0.7602 and 0.8182, respectively). TS also showed high repeatability (0.6827). The genotypic effects were significant at 1% level for days for fruit ripening, fruit size, vegetative vigor, yield per plant, TS, and BS; at 5% level for general scale; and at 10% level for incidence of rust, degree of inclination, and percentage of fruit float. It was possible to distinguish 20 superior genotypes in terms of maturation, among which the selection gains for the genotypic clusters were 46.14, 45.92 and 41.56% for indefinite, early, and late maturation, respectively, by applying a selection intensity of 11.43%. Genotypes 25, 26, 73, 93, and 100 could be used for early maturing varieties, whereas genotypes 155 and 189 could be used for late-maturing varieties. The most promising genotypes for composing a variety, regardless of the maturation period, were 20, 39, 90, 112, and 190, as these were among the five best genotypes ranked in the three selection processes, demonstrating that they added superior desired morphoagronomic characteristics. It is concluded that there is genetic variability among the 175 genotypes evaluated, as well as significant genetic effects to be explored in the pool gene of individuals originating from the 'ES8152' variety.